There are no other notable options provided by Software Lag Switch. In addition, you can toggle the hotkey mode between pressing it and holding it down, as well as enable sound. It is possible to establish a global hotkey for activating the program, specify the method used between UDP (whole network) and firewall (only the current computer), as well as point out the time frame for keeping a pulse on and disabling it. You can run the application and check out the friendly interface that consists of a small window with an intuitive structure. The installation operation takes little time to finish and does not require special input from the user. Only one step, go to L2 Features > Switching > LAG > Static LAG, select Group ID as LAG1, select Port 1 and Port 2, click Apply.Software Lag Switch is a simple-to-use application that comes in handy whenever you want to simulate a poor Internet connection, in order to fend off other people that may be using it. Only one step, go to L2 Features > Switching > LAG > Static LAG, select Group ID as LAG1, select Port 3 and Port 4, click Apply. Go to L2 Features > VLAN > 802.1Q VLAN > Port Config, set the PVID value as 10, 20, 30 for LAG 1, port 2 and port 3 respectively.Ĭlick LAGS in Port Config page and then set the PVID value as 10, 20 for LAG1 and LAG2.Ĭlick UNIT1 in Port Config page and then set the PVID value as 30 for port 5. Then verify the VLANs on VLAN Config page.
Note: When adding ports to VLAN 30, as VLAN 30 including LAG ports and general port, please click UNIT 1 to select general port 5 and then click LAGS to select LAG port 1and LAG port 2. Go to L2 Features > VLAN > 802.1Q VLAN > VLAN Config, create VLAN 10, VLAN 20 and VLAN 30 add Untagged port LAG1 to VLAN 10 add Untagged port LAG2 to VLAN 20 add Untagged port LAG1, LAG2, and port5 to VLAN 30. Then verify the LAGs on the LAG Table page. Go to L2 Features > Switching > LAG > Static LAG, select Group ID as LAG1, select Port 1 and Port 2, click Apply choose then Group ID as LAG2, and select Port 3 and Port 4, click Apply. LAG Configurations on Switch A, Switch B, and Switch C:Įgress Rule and PVID settings for Switch A: With correct PVID settings, both department A and department B can access the internet, but cannot communicate with each other.
Hosts in different departments cannot communicate with each other all hosts can access the internet.Users need to improve the bandwidth and redundancy of the link between the switches.Sometimes, we may encounter the application that needs to use these two technologies at the same time here is a configuration example. LAG (Link Aggregation Group) is a technology that can aggregate multiple physical ports into a logical interface, increasing link bandwidth and providing backup ports to enhance the connection reliability. A LAN can be divided into several VLANs logically, and only the hosts in the same VLAN can communicate with each other. VLAN (Virtual Local Area Network) is a technology that can modify the broadcasting domain.
0 kommentar(er)
